|
Introduction |
Is the Front Bumper on your iRobot Roomba i7 stuck or not moving freely? If you notice that your device is showing you an Error 9 or Error 16, it means that there is an issue involving the Front Bumper of your Roomba. To resolvesolve either of these problems, you can try tapping the bumper several times to help dislodge any debris that may be trapped inside and preventing your bumper from operating correctly. If this doesn’t help fix your front bumper and it is dislodged, then you will need to re screw the Front Bumper back into place. | | The Front Bumper is on the top of the device (if looking from an overhead view). The purpose of the Front Bumper is to detect any walls or boarders that may be in the room that it is cleaning and the. The Bumper is used to prevent it from damaging them by using the sensors in the front to slow down and gently touch the walls/boarders. | | | Before you begin using this guide, make sure that your Roomba is turned off and disconnected from the charging station, or Home Base. |
|