crwdns2933423:0crwdne2933423:0

crwdns2944351:0crwdnd2944351:0Mavic 2 Main Board Replacementcrwdnd2944351:0crwdne2944351:0

crwdns2933797:0Robert Contractioncrwdnd2933797:0crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Robert Contraction

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0
crwdns2866306:0crwdne2866306:0
Mavic 2
Type
replacement
Thing
Main Board
Title
Mavic 2 Main Board Replacement
Introduction
# Turn drone upside down to expose underside plate.
# Begin to remove all 8 screws from the plate . Remember the 2 middle screws are bigger than the other 6 so set those aside separately.
# Pull plate off, exposing the main board.
# Detach 3 ribbons on the top of the board. Near the head of the drone. Use spreader.
# Remove screw holding circuit board in. 1 near the top, 2 near the bottom.
# Pop of all 4 antennas at the bottom of the circuit board. Use spreader.
# Pull away antennas and remove board carefully.
# Replace new circuit board.
# Attach 3 ribbons.
# Attach 4 antennas.
# Screw circuit board back in.
# Place the plate back on and screw back in all 8 screws.
Time Required Min
crwdns2931273:0crwdne2931273:0
Time Required Max
crwdns2931273:0crwdne2931273:0
Imageid
crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
Difficulty
Moderate
Conclusion
To reassemble your device, follow these instructions in reverse order.
Author
Public
crwdns2853046:0crwdne2853046:0

crwdns2935255:0crwdne2935255:0

  • In Progress added.
  • Community-Contributed Guide added.

crwdns2933623:0crwdne2933623:0

crwdns2933815:01crwdne2933815:0
crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933815:02crwdne2933815:0
crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933815:03crwdne2933815:0
crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0