crwdns2944351:0crwdnd2944351:0Hover-1 Charger Gyroscope Sensor Board Replacementcrwdnd2944351:0crwdne2944351:0

crwdns2866306:0crwdne2866306:0	Hover-1 Charger
Type	replacement
Thing	Gyroscope Sensor Board
Title	Hover-1 Charger Gyroscope Sensor Replacement
Introduction	If you are having trouble balancing on your Hover-1 Charger (H1-COL), there may be an issue with its gyroscope sensor board. Before you begin disassembling your hoverboard, check out our troubleshooting page addressing [https://www.ifixit.com/Wiki/Hover-1_Charger_Troubleshooting#Section_Hoverboard_does_not_balance|hoverboard balancing]. If the problem persists once you have troubleshooted, this guide will help you replace your hoverboard’s gyroscope sensor board. Make sure to wear an anti-static wrist strap to protect yourself and the electronics against buildup of static electricity.
Time Required Min	crwdns2931287:020crwdne2931287:0
Time Required Max	crwdns2931287:020crwdne2931287:0
Imageid	crwdns2933769:0crwdne2933769:0 crwdns2933771:0crwdne2933771:0
Difficulty	Moderate
Conclusion	To reassemble your device, follow these instructions in reverse order.
Author	Melanie Hardell
Public	crwdns2853046:0crwdne2853046:0

crwdns2933809:0crwdne2933809:0

• crwdns2933811:01crwdnd2933811:0emptycrwdnd2933811:0Hover-1 Charger Unplugging the Batterycrwdne2933811:0

crwdns2935255:0crwdne2935255:0

crwdns2933623:0crwdne2933623:0

crwdns2933815:01crwdne2933815:0

crwdns2933769:0crwdne2933769:0

crwdns2933771:0crwdne2933771:0