crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2944351:0crwdnd2944351:0Makita Jack Hammer HM1307CB Controller Cover Removalcrwdnd2944351:0crwdne2944351:0

crwdns2933797:0Taylor Dixoncrwdnd2933797:0crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Taylor Dixon

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0
crwdns2866306:0crwdne2866306:0
Makita Jack Hammer HM1307CB 2011
Type
replacement
Thing
Controller Cover
Title
Makita Jack Hammer HM1307CB 2011 Controller Cover Removal
Introduction
This guide is a pre-requisite and is not meant to be used on its own! These steps illustrate the removal of the controller cover in a Makita HM1307CB jack hammer.
Time Required Min
crwdns2931287:015crwdne2931287:0
Time Required Max
crwdns2931287:020crwdne2931287:0
Imageid
crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
Difficulty
Moderate
Conclusion
To reassemble your device, follow these instructions in reverse order.
Author
Taylor Dixon
Public
crwdns2853046:0crwdne2853046:0

crwdns2943215:0crwdne2943215:0

  • Phillips #2 Screwdriver x1 added.
  • 5 mm Hex Key x1 added.
  • 3mm Hex Key (or Bit) x1 added.

crwdns2935255:0crwdne2935255:0

  • In Progress added.
  • Prerequisite Only added.

crwdns2933623:0crwdne2933623:0

crwdns2933815:01crwdne2933815:0
crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
stepid 243214 stepid 243214
crwdns2933815:02crwdne2933815:0
crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
stepid 243215 stepid 243215
crwdns2933815:03crwdne2933815:0
crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
stepid 243218 stepid 243218