|
Introduction |
| Not sure what to do with all the adhesive strips in your back cover kit? You’ve come to the right place! This guide shows how to use the back cover adhesive kit for the Galaxy S series with glass backs (S7 and newer). It also includes instructions on how to transfer and install various back cover components, such as the rear bezel and fingerprint sensor. | | ''You may not need to use all the adhesive strips included in the kit.'' If you are transferring the fingerprint sensor, you willmay need some double-sided tape such as Tesa tape. | | | For a list of adhesive strips for the Galaxy S phone, [https://www.ifixit.com/Store/Parts/Samsung-Galaxy-S-Series/Adhesive_Strips|follow this link]. | | | When applying adhesive strips like these, here are some general tips: | | | * '''The adhesive exposed when peeling the clear liner determines which surface the strip should be applied to first.''' This layer usually peels easily. Locate the surface that aligns with the exposed adhesive. | | * To make adhesive application easier, you can align an unexposed strip to its intended position on the phone, then [https://d3nevzfk7ii3be.cloudfront.net/igi/a6EfdSi3YTRDsMVw.large|tape one edge down to hold the strip in place]. This will allow you to peel away the plastic liners and expose the adhesive without losing alignment. | | * When you are ready to apply the adhesive, '''peel away the clear plastic liner first'''. This layer usually peels easily. If there are multiple clear plastic layers, remove the clear layer that exposes adhesive. | | * '''The adhesive exposed after peeling the clear liner determines which surface the strip should be applied to first.''' Locate the surface that aligns with the exposed adhesive. |
|