|
Introduction |
| Not sure what to do with all the adhesive strips in your back cover kit? You’ve come to the right place![br] | | [br] | | This guide shows how to use the back cover adhesive kit for the Galaxy S series with glass backs (S7 and higher). It also includes instructions on how to transfer and install various back cover components, such as the camera bezel and fingerprint sensor. | | | You may not need to use all the adhesive strips included in the kit. If you are transferring the fingerprint sensor, you will need some double-sided tape such as Tesa tape. | | When applying adhesive strips like these, follow thesehere are some general guidelinestips: | | #* To make adhesive application easier, you can align the unexposed strips, [https://d3nevzfk7ii3be.cloudfront.net/igi/a6EfdSi3YTRDsMVw.large|then tape an edge down to hold the strip in place|new_window=true]. This will still allow you to peel away the plastic liners without losing alignment.
* '''Peel away the clear plastic liner first'''. This layer usually peels easily. If there are multiple clear plastic layers, remove the clear layer that exposes adhesive.
#* '''The adhesive exposed adhesiveafter peeling the clear liner determines which surface the strip should be applied to first.''' Locate the surface that aligns with the exposed adhesive.
# Carefully align and apply the adhesive to that surface.
# Peel away any remaining clear liners as well as the colored liner. This will expose the other side of the adhesive strip. |
|