crwdns2915892:0crwdne2915892:0
The Zoom Q3HD is a handy video/audio recording device released in 2010 How to clean the lens from inside
crwdns2942213:0crwdne2942213:0
-
-
Remove the two screws from the bottom of the device.
-
-
-
Flip the device over and remove the four screws bordering the grate of the device.
-
-
-
On the front of the device, slide the battery compartment cover off by pushing inward and sliding downward.
-
-
-
Remove the two screws from the lip of the battery compartment.
-
-
-
-
Remove the final screw from the bed of the battery compartment.
-
-
-
Run the pry tool along the edges of the device to begin separating the device in two halves.
-
-
-
Apply upward pressure to fully separate the device into two halves.
-
-
-
Lift display screen keeping the top half close to the board.
-
-
-
Gently flip the black clip up attaching the ribbon of the screen to the circuit board.
-
-
-
Gently slide the ribbon from the circuit board, removing the screen.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935229:02crwdne2935229:0
crwdns2915084:0crwdne2915084:0
Ohio State, Team 1-1, Mccook Fall 2014 crwdns2935289:0Ohio State, Team 1-1, Mccook Fall 2014crwdne2935289:0
OSU-MCCOOK-F14S1G1
crwdns2931471:04crwdne2931471:0
crwdns2935303:01crwdne2935303:0
crwdns2944067:03crwdne2944067:0
My zoom q3HD only have the red light turned on when powering up. No display at all. What is happening? How can I claim warranty? I didn't use the device more than a year. Help me
This is not comlete, leaves you half way through, would be great if you could finish this, thank you.
Yes it would be good to see it finished. I am half way through taking mine apart to clean the lens amd i don't know if i should proceed or not. Its the 2nd time the lens has fogged up. My 2nd q3hd.
