crwdns2915892:0crwdne2915892:0
If your device fails to power on, it may be time to replace the power cord. Follow these instructions to replace the power cord in the Zebra ZP 450.
crwdns2942213:0crwdne2942213:0
-
-
Using the TR10 Torx screwdriver, remove the four 8mm screws from the bottom of the device.
-
Remove the three 12mm screws from the bottom of the printer using a Phillips #1 screwdriver.
-
-
-
-
Using the iFixit opening pick, remove the plastic cover.
-
-
-
Using the Phillips #1 screwdriver, remove the single 14 mm screw from the clamp that is holding the power cord.
-
Remove the power cord from the device.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.