crwdns2915892:0crwdne2915892:0
No one can question the fact that you have the coolest snowboarding video ever. Your Zeal Optics iON goggles perfectly captured you doing a double backflip, landing it, and then riding straight into a tree, cracking the camera lens. Use this guide to replace the broken lens to start recording part 2.
crwdns2942213:0crwdne2942213:0
-
-
Hold the iON in your hands with your thumbs on the clips next to the middle of the lens.
-
Pull the rubber housing apart to release the first two clips.
-
-
-
Grab the inside of the plastic nose rest with your thumb and index finger.
-
Rotate the nose rest upwards until you feel that it is free from the lens.
-
-
-
Grab the top of the goggle frame that holds the camera assembly.
-
Rotate the frame outwards until you feel that the clips inside it are free.
-
-
-
While firmly holding the goggles with the palm of one hand, grab the top right corner of the frame and rotate it away from the lens.
-
-
-
While holding the goggles in one hand, use the other to grab the lens from opposite ends, and rotate it out of the housing and away from any remaining clips.
-
-
-
Remove the four 7.1 mm Phillips screws securing the camera housing to the goggle frame.
-
-
-
-
Peel back the rubber battery cover from the inner left side of the frame.
-
While firmly holding the battery cover, pull the bottom of the strap mount cover up and off of the frame
-
-
-
Once the bottom is free, continue pulling to free the top of the strap mount cover from the frame.
-
-
-
Pull the battery out of its recess in the frame.
-
-
-
Peel the rubber keypad cover up from the inner right side of the frame.
-
While firmly holding the keypad cover, pull the top of the strap mount cover up and off of the frame
-
-
-
Once the bottom is free, continue pulling to free the bottom of the strap mount cover from the frame.
-
-
-
Hold the strap mount cover away from the frame and remove the keypad.
-
-
-
Grab the viewfinder housing and pull it out of its recess.
-
-
-
Place one of your hands near the center of the frame with your thumb next to the camera housing.
-
With your other hand, grab the camera housing and pull it up and out of the frame.
-
-
-
Remove the viewfinder assembly by pulling it through the opening in the top of the frame.
-
-
-
In the same manner described above, remove the battery from the frame.
-
-
-
Grab the outer element of the lens and unscrew it by rotating it counterclockwise.
-
Once the lens is completely unscrewed, remove it from the camera assembly.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2947410:01crwdne2947410:0
Hi, Any ideas where I can purchase a replacement camera lens for the iON Goggles? Mine is scratched, I tried to buff out the scratch but it leaves a blurred spot still on the video.
