crwdns2915892:0crwdne2915892:0
This guide will demonstrate how to replace the front camera from the mother board of the ZTE Lever phone.
crwdns2942213:0crwdne2942213:0
-
-
Remove the SD card and the Sim card from the device.
-
-
-
Use an iFixit opening tool to separate the back from the device.
-
-
-
Remove the two 1.6mm Phillips #0 screws from the battery plug cover.
-
Remove the cover.
-
-
-
-
Disconnect the battery cable from the motherboard with a plastic opening tool.
-
-
-
Use your hands, or a plastic opening tool, to pry the battery from the phone.
-
-
-
Unscrew the three 1.6mm Philllips #0 screws on the plastic cover that are near the top edge of the phone by the camera.
-
Pry off the plastic cover using the iFixit opening tool.
-
-
-
Unplug the front-facing camera press fit connector cable using the iFixit opening tool.
-
Remove the camera from the motherboard.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.