crwdns2915892:0crwdne2915892:0
This guide is designed to assist in the replacement of the D-Pad for the ZD-N Plus Wireless Controller. Directional pads can be purchased at local electronics stores.
crwdns2942213:0crwdne2942213:0
-
-
Remove the seven 12mm JIS #00 screws that hold the back panel in place.
-
-
-
Lift up on the back panel of the ZD-N Plus to remove it from the rest of the controller.
-
-
-
Use an opening tool to pry the battery from its original position.
-
-
-
-
Use an opening tool to pry the connector away from the two metallic prongs.
-
-
-
Remove the battery from the controller.
-
-
-
Remove the electrical connector attaching each rumble motor to the controller.
-
Lift up on the circular section of the rumble to remove it from the controller.
-
-
-
Remove the three 1.2mm JIS #00 screws that hold the motherboard in place.
-
-
-
Lift the motherboard out of the controller.
-
-
-
Simply remove the plastic piece of the directional pad. It is not glued in so it should come out easily.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.