crwdns2915892:0crwdne2915892:0
This guide is created to explain how to replace the LB and RB buttons on your ZD-N208 Plus Wireless Controller. Bumpers can be found on eBay for $3.00.
crwdns2942213:0crwdne2942213:0
-
-
Remove the seven 12mm JIS #00 screws that hold the back panel in place.
-
-
-
Lift up on the back panel of the ZD-N Plus to remove it from the rest of the controller.
-
-
-
Use an opening tool to pry the battery from its original position.
-
-
-
-
Use an opening tool to pry the connector away from the two metallic prongs.
-
-
-
Remove the battery from the controller.
-
-
-
Remove the electrical connector attaching each rumble motor to the controller.
-
Lift up on the circular section of the rumble to remove it from the controller.
-
-
-
Remove the three 1.2mm JIS #00 screws that hold the motherboard in place.
-
-
-
Lift the motherboard out of the controller.
-
-
-
The LB/RB buttons can be easily pulled from the top of the controller.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935227:0crwdne2935227:0