crwdns2915892:0crwdne2915892:0
This guide has only a few simple steps to get to the microphone. However, soldering is required to fully detach the microphone from the headset and install a replacement. Please refer to the soldering technique guide for instructions on soldering and desoldering.
crwdns2942213:0crwdne2942213:0
-
-
Use the flat end of a spudger to pry out the rubber stopper at the base of the boom.
-
-
-
Remove the single 6 mm flathead #2.0 screw exposed after removing the rubber stopper.
-
-
-
-
Lift the joint of the boom up and over its pivot point to separate the microphone from the headset.
-
-
-
Using the flat end of the metal spudger, pry the back plate off the boom.
-
-
-
Using the flat end of the plastic spudger, gently pry the microphone out of its casing.
-
Desolder the two wires from the back of the microphone. For instructions on how to solder and desolder, please see the soldering technique guide.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935229:04crwdne2935229:0
crwdns2915084:0crwdne2915084:0
Cal Poly, Team 17-37, Amido Winter 2015 crwdns2935289:0Cal Poly, Team 17-37, Amido Winter 2015crwdne2935289:0
CPSU-AMIDO-W15S17G37
crwdns2931471:04crwdne2931471:0
crwdns2935297:05crwdne2935297:0
crwdns2947412:09crwdne2947412:0
Is a replacement microphone available from iFixit?
What do you replace the mic with?
They have the microphone for sale
daniel david guerrerogarcia - crwdns2934203:0crwdne2934203:0
Would it presumably be just as easy to replace the microphone speaker with one from another headset, granted it fits ?
Any mod to make the cable removable?
