crwdns2915892:0crwdne2915892:0
Stop holding your Xbox 360 wireless controller together with duct tape. Use this guide to replace your old broken rear case.
crwdns2860944:0crwdne2860944:0
crwdns2860947:0crwdne2860947:0
crwdns2890040:0crwdne2890040:0
-
-
Depress the battery release button on the top of the controller.
-
Remove the battery holder from the controller.
-
-
-
Use a pair of tweezers to peel the barcode sticker from the battery compartment.
-
-
-
-
Remove the seven 9.3 mm T8 Security Torx screws securing the rear case to the front case.
-
-
-
Insert a Spudger between the front and rear cases along the left edge of the controller.
-
Rotate the spudger toward the front of the controller, prying the two cases apart.
-
-
-
Insert a spudger between the front and rear cases, near the headphone jack.
-
Rotate the spudger toward the front of the controller to pry the two cases apart.
-
-
-
Grasp the controller by the battery compartment and the headphone jack.
-
Lift the battery compartment away from the headphone jack, separating the rear case from the front case and logic board.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2869486:0crwdne2869486:0
crwdns2878426:022crwdne2878426:0