crwdns2915892:0crwdne2915892:0
If the battery of your Wyze WVCR200s robot vacuum isn't charging or won't hold a charge, you may need to replace the battery. This guide demonstrates how to replace the battery of your Wyze WVCR200s. Start off by checking the connection from the battery to the port. For your safety, make sure the device in fully powered down before attempting to remove the battery.
crwdns2942213:0crwdne2942213:0
-
-
Flip the vacuum upside down so the bottom is facing up.
-
-
-
Pinch the blue tabs below the rotating brush towards each other.
-
Lift the plastic housing surrounding the rotating brushing straight up, and the remove it from the vacuum.
-
-
-
-
To remove the rotating brush, lift one end of the brush upwards, and remove.
-
-
-
Use a screwdriver to remove four screws along the edge, just above where the brush was removed.
-
-
-
Lift the battery cover up and out of the vacuum.
-
-
-
Lift the battery out from underneath the cover.
-
Carefully disconnect the battery from the vacuum port.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935227:0crwdne2935227:0
crwdns2915084:0crwdne2915084:0
UMass Dartmouth, Team 5-5, Ramos Spring 2023 crwdns2935289:0UMass Dartmouth, Team 5-5, Ramos Spring 2023crwdne2935289:0
UMASSD-RAMOS-S23S5G5
crwdns2931471:04crwdne2931471:0
crwdns2935297:05crwdne2935297:0
