crwdns2915892:0crwdne2915892:0
The main motherboard is the circuit board that controls all the main components such as storing electrical components and helps them communicate to each other. It is vital to have a working motherboard to use your device. This guide will walk you through replacing the main motherboard of the Wyze Cam V2.
crwdns2942213:0crwdne2942213:0
-
-
Open up the camera stand to expose the bottom plate of the camera.
-
Remove two 4 mm silver screws using the Phillips #0 screwdriver.
-
-
-
Using the iFixit opening tool, carefully pry open the bottom plate to gain access to the camera's internals.
-
-
-
Open up the back panel using the iFixit opening tool and unclip the panel from the rest of the device.
-
-
-
crwdns2935267:0crwdne2935267:0Tweezers$3.99
-
Using the angled slim tweezers, disconnect the cord and pull it gently off of the motherboard.
-
-
-
Remove the single 6 mm screw located deep inside the device using a Phillips #000 screwdriver.
-
Carefully remove the motherboard from the device.
-
-
-
Remove the remaining two 6 mm screws from the motherboard with a Phillips #0 screwdriver.
-
-
crwdns2935267:0crwdne2935267:0Tweezers$4.99
-
Using the precision tweezers, detach the charging port’s motherboard from the camera’s motherboard.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.