crwdns2942213:0crwdne2942213:0
-
-
Place CHiP on its back so that its stomach is facing you.
-
-
-
There are three small hex screws connecting the battery to CHiP. Remove all screws with a hex screwdriver and remove battery casing.
-
-
-
Once the top face of the battery is off, you will see a small rectangular box that the batteries are inside. There are 4 Phillips head screws in the box. Remove all screws with a Phillips head screwdriver.
-
-
-
-
Once the battery is removed from body, the battery should be connected by a red and black wire. There is a red rectangular connector that easily pulls apart. Pull apart the red rectangular connector.
-
-
-
Remove the 4 Phillips screws shown.
-
-
-
Pull up top part of toy and remove the connecting wires.
-
Unscrew the 2 Phillips head screws. CHiP should be viewed as seen in the third picture.
-
-
-
Remove the 4 Phillips screws to separate the head from the body.
-
-
-
Remove the 4 Phillips screws on back of the head, and pull off the casing for the back of the head.
-
-
-
Unscrew the screw on the ear with a Phillips screwdriver, and pull off the plastic connector. Remove the ear from head.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2915084:0crwdne2915084:0
Linn Benton Community College, Team S1-G5, Johnson Fall 2018 crwdns2935289:0Linn Benton Community College, Team S1-G5, Johnson Fall 2018crwdne2935289:0
LBCC-JOHNSON-F18S1G5
crwdns2931471:04crwdne2931471:0
crwdns2935297:010crwdne2935297:0
crwdns2917034:0crwdne2917034:0
It’s almost a disassembly, probably quite hard to do. I did disassemble a MiPosaur, but some parts broke off. (!!!)
