crwdns2915892:0crwdne2915892:0
This guide will demonstrate how to replace the Power Supply inside the Wii Balance Board.
crwdns2942213:0crwdne2942213:0
-
-
Flip device upside-down so the plastic white board is facing the ground.
-
Locate the four feet in the corners of the Balance Board.
-
Unscrew the three 12.7 mm Phillips screws from each foot cover.
-
-
-
Remove the gray plastic ring from the actual foot by lifting it up.
-
-
-
Separate the loose foot from the device by lifting it up.
-
-
-
Repeat steps two and three on the remaining four feet.
-
-
-
-
Unscrew the ten 12.7 mm Phillips #1 screws.
-
-
-
Lift off the gray back cover.
-
-
-
Locate the gray battery compartment.
-
Push the tab on the bottom and lift up completely to remove the cover to the batteries.
-
-
-
Unscrew the two 6.35 mm Phillips #1 screws.
-
Slide the battery case out.
-
-
-
Unscrew the four 12.7 mm #1 screws.
-
-
-
Lift the frame, circuit board, and power supply out of the front case. These components are all connected.
-
-
-
Lift out the power supply. It is not screwed in.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935227:0crwdne2935227:0
crwdns2915084:0crwdne2915084:0
Cal Poly, Team 13-8, Forte Fall 2014 crwdns2935289:0Cal Poly, Team 13-8, Forte Fall 2014crwdne2935289:0
CPSU-FORTE-F14S13G8
crwdns2931471:05crwdne2931471:0
crwdns2935297:015crwdne2935297:0
crwdns2947410:01crwdne2947410:0
Top Anleitung, aber wo kann ich die Platine herbekommen? Danke!!!
