crwdns2915892:0crwdne2915892:0
This guide will demonstrate how to replace the back cover of the Balance Board.
crwdns2942213:0crwdne2942213:0
-
-
Flip device upside-down so the plastic white board is facing the ground.
-
Locate the four feet in the corners of the Balance Board.
-
Unscrew the three 12.7 mm Phillips screws from each foot cover.
-
-
-
Remove the gray plastic ring from the actual foot by lifting it up.
-
-
-
-
Separate the loose foot from the device by lifting it up.
-
-
-
Repeat steps two and three on the remaining four feet.
-
-
-
Unscrew the ten 12.7 mm Phillips #1 screws.
-
-
-
Lift off the gray back cover.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.