crwdns2915892:0crwdne2915892:0
This guide will help cover a left undone outlet hole or if you are putting a new outlet cover. This guide will help prevent a hazardous zone for children, especially for children under three years old, who can easily put the cord in their mouth or get their hand stuck inside the wall. The guide will also prevent any bugs or mice to get in and out of the hole and it would be best if the hole would be covered up with a proper blank wall outlet cover and this guide is here to help you do that.
crwdns2942213:0crwdne2942213:0
-
-
Remove any hazardous pieces from previous cover.
-
-
-
Insert any cable or cables that may be hanging out inside of the wall hole.
-
-
-
-
Insert two screws into the holes of the new wall cover.
-
-
-
Line up the screws in the plate with the screw holes in the wall.
-
Tighten the screws slightly with your hands to ensure that both screws have found the proper holes.
-
-
-
Tighten the two screws with a flathead screwdriver.
-
-
-
Double check that the wall cover plate does not have a gap, and it is completely attached to the wall.
-
If any gap is detected, push the plate to the wall and continue to tighten the screws until the gap completely closes.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935227:0crwdne2935227:0
crwdns2915084:0crwdne2915084:0
CSU Los Angeles, Team S1-G23, Harris Spring 2021 crwdns2935289:0CSU Los Angeles, Team S1-G23, Harris Spring 2021crwdne2935289:0
CSULA-HARRIS-S21S1G23
crwdns2934841:01crwdne2934841:0
crwdns2935297:02crwdne2935297:0
