crwdns2915892:0crwdne2915892:0
Use this guide to replace the motor of your Wahl Professional Designer.
crwdns2942213:0crwdne2942213:0
-
-
Unscrew the 12 mm Phillips head screws located at the top of the cover and at the bottom two corners, using a Phillips #1 Screwdriver.
-
-
-
Remove the wires connected to the motor by firmly grasping both sides of a wire and wiggling until it is released.
-
-
-
-
Unscrew the two 20.5 mm Phillip head screw located on the motor using a Phillip's #1 screwdriver.
-
-
-
Gently remove the motor from the device.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935229:02crwdne2935229:0