crwdns2915892:0crwdne2915892:0
The power cord connects the clipper to a power supply. If the power cord wiring breaks due to repeated bending, the power cord may need replacement. Replacing a broken power cord makes sure the clippers receive the power needed to run the device.
crwdns2942213:0crwdne2942213:0
-
-
Remove the two 5.0 mm JIS #1 screws to loosen the cutting blades.
-
-
-
Lift the bottom blade straight up from the device body to remove it.
-
-
-
Remove the three 9.0 mm JIS #1 screws attaching the base of the blade assembly to the body.
-
-
-
Lift the base of blade assembly straight up off of the body.
-
-
-
-
Remove the two 12.0 mm JIS #1 screws on the back of the device body.
-
-
-
Remove the 13.0 mm Phillips #2 screw on the side of the device body.
-
This screw is located on the opposite side of the body from the switch.
-
-
crwdns2935267:0crwdne2935267:0Tweezers$4.99
-
Remove the spring on the side of the body using tweezers.
-
-
-
Pry the body case off of the device using a spudger.
-
-
-
Remove one 7.5 mm JIS #1 screw from the switch base.
-
-
-
Unplug the cord terminal from the motor connector.
-
-
-
Remove the cord from the device base by pulling gently.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935227:0crwdne2935227:0
crwdns2915084:0crwdne2915084:0
IUPUI, Team S7-G3, Baechle Fall 2017 crwdns2935289:0IUPUI, Team S7-G3, Baechle Fall 2017crwdne2935289:0
IUPUI-BAECHLE-F17S7G3
crwdns2931471:03crwdne2931471:0
crwdns2935297:08crwdne2935297:0
