crwdns2915892:0crwdne2915892:0
This guide shows how to remove and replace the pump housing cover for the Wacker Pump PT3A 2012.
crwdns2942213:0crwdne2942213:0
-
-
Grab the plastic housing at the end of the spark plug wire.
-
Pull firmly to disconnect the wire from the spark plug.
-
-
-
-
Use the included wrench to loosen the four black knobs securing the pump housing cover.
-
If the wrench is missing, slide a screwdriver shank through the knob and twist to loosen the knobs.
-
-
-
Slide the pump housing cover out of the pump and remove it.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.