crwdns2942213:0crwdne2942213:0
-
-
Using a Phillips #1 screwdriver, remove the 4.8mm screw on the battery cover by twisting the screwdriver counter-clockwise.
-
-
-
Remove the two AAA batteries by pulling on one end of the battery and lifting it straight out.
-
-
-
-
Remove 4 13.8mm screws holding the device back using a Phillips #1 screw driver.
-
-
-
Lift directly up to remove the switch and lay the wire down to the side.
-
Once the switch has been taken out you can remove the switch's casing.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935227:0crwdne2935227:0
crwdns2915084:0crwdne2915084:0
USF Tampa, Team 2-4, Sullivan Fall 2015 crwdns2935289:0USF Tampa, Team 2-4, Sullivan Fall 2015crwdne2935289:0
USFT-SULLIVAN-F15S2G4
crwdns2931471:03crwdne2931471:0
crwdns2935297:012crwdne2935297:0
crwdns2944067:02crwdne2944067:0
Good work.
I have done it the same way,
the wire at the switch was bad soldered,
but it was easy to repair it and i soldered it new.
Nice.
My baby’s phone keeps turning itself off. The switch is in the ON position but it keeps turning OFF and singing the off song. I have opened the phone and even held the switch to ON but it still keeps turning OFF even without the switch moving. Any suggestions?
