crwdns2915892:0crwdne2915892:0
USB port not working anymore? Screen scratched, cracked, or broken? Or is the watch failing to work altogether? This guide can help. Note: This guide requires soldering.
crwdns2942213:0crwdne2942213:0
-
-
Flip the watch over with the back facing up.
-
-
-
Remove the four 6.0 mm screws on the back plate with the Phillips #00 screwdriver.
-
-
-
Gently pull the back plate from the watch casing.
-
-
-
-
Lift the master switch from the circuit board.
-
-
-
Gently push on the display from the front, near the camera. The circuit board and display will pop out through the back.
-
-
-
Lift the circuit board carefully from the casing, without breaking or detaching the speaker wires at the bottom of the circuit board.
-
-
-
De-solder the black speaker wire from the circuit board.
-
-
-
De-solder the red speaker wire, as in the previous step.
-
-
-
Wait for the solder to cool down and solidify, then remove the circuit board from the casing.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935229:07crwdne2935229:0
crwdns2915084:0crwdne2915084:0
USF Tampa, Team 10-6, Remmell Spring 2016 crwdns2935289:0USF Tampa, Team 10-6, Remmell Spring 2016crwdne2935289:0
USFT-REMMELL-S16S10G6
crwdns2931471:04crwdne2931471:0
crwdns2935297:012crwdne2935297:0
crwdns2944067:02crwdne2944067:0
Where can I buy the circuit board ?? Please send me a link or just post it please. Thanks
Where can I buy replacement and how much should it cost?
