crwdns2942213:0crwdne2942213:0
- 
   
   - 
                     
            Start off by using a Philips #2 screwdriver to remove all 8 10mm exterior screws on the rear of the device. 
 
- 
                     
            
- 
   
   - 
                     
            After screws have been removed, open fan up. Inside remove the black and silver directional fins. 
 
- 
                     
            
- 
                     
                                                
- 
   
   - 
                     
            Remove the black 5mm screw inside of the fan blade cylinder. 
 
- 
                     
            
- 
   
   - 
                     
            Find and locate the 10 mm screws on both sides of the circuit board enclosure. Remove both screws. 
 
- 
                     
            
- 
   
   - 
                     
            Take out the fan cylinder and the circuit board enclosure. 
 
- 
                     
            
- 
   
   - 
                     
            Look inside the frontal shell of the fan and locate power button. 
- 
                     
            Remove by gently pulling button off notch and replace with new power button. 
 
- 
                     
            
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935229:02crwdne2935229:0
