crwdns2915892:0crwdne2915892:0
In this replacement guide, step by step instructions will show how to replace the circuit board located inside of the Vornado Duo.
crwdns2942213:0crwdne2942213:0
-
-
Start off by using a Philips #2 screwdriver to remove all 8 10mm exterior screws on the rear of the device.
-
-
-
-
Loosen 5 mm screw at bottom of fan blade located inside the blades.
-
-
-
Remove fan blade after unscrewing top 2 screws located on each side of the covered board.
-
-
-
Unsolder the circled spots on the mother board and resolder each wire to corresponding spot.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935229:02crwdne2935229:0