crwdns2933423:0crwdne2933423:0

Vivedino Troodon Screens and Macros

crwdns2942213:0crwdne2942213:0

  1. Vivedino Troodon Screens and Macros, EZ Z Offset: crwdns2935265:01crwdnd2935265:01crwdnd2935265:03crwdne2935265:0 Vivedino Troodon Screens and Macros, EZ Z Offset: crwdns2935265:01crwdnd2935265:02crwdnd2935265:03crwdne2935265:0 Vivedino Troodon Screens and Macros, EZ Z Offset: crwdns2935265:01crwdnd2935265:03crwdnd2935265:03crwdne2935265:0
    • Macro> Z Offset Auto Setup> EZ Z Offset. Follow the prompts and afterwards, your Z Offset will be dialed in and stored.

  2. Vivedino Troodon Screens and Macros: crwdns2935265:02crwdnd2935265:01crwdnd2935265:02crwdne2935265:0 Vivedino Troodon Screens and Macros: crwdns2935265:02crwdnd2935265:02crwdnd2935265:02crwdne2935265:0
    • Macros for different filaments. The temperature changes for each.

crwdns2915888:0crwdne2915888:0

To reassemble your device, follow these instructions in reverse order.

Tiny Machines 3D

crwdns2935283:011/16/19crwdne2935283:0

3,019 crwdns2915208:0crwdne2915208:0

crwdns2935297:014crwdne2935297:0

crwdns2915084:0crwdne2915084:0

Tiny Machines 3D crwdns2935289:0Tiny Machines 3Dcrwdne2935289:0

Community

crwdns2931471:05crwdne2931471:0

crwdns2935297:041crwdne2935297:0

crwdns2947410:01crwdne2947410:0

Hello, I am trying to create macros to control my LEDs. I have working ones that turn them off and on, but every time I try to use the M150 command to change colors, it says M150 command not supported. Any ideas?

Thanks for your help!!

Roger “Pork Chop” Porcelli - crwdns2934203:0crwdne2934203:0

crwdns2917038:0crwdne2917038:0

crwdns2936625:0crwdne2936625:0:

crwdns2936751:024crwdne2936751:0 2

crwdns2936753:07crwdne2936753:0 2

crwdns2936753:030crwdne2936753:0 12

crwdns2942667:0crwdne2942667:0 449