crwdns2915892:0crwdne2915892:0
Removing the Exhalation Corner Assembly is a prerequisite step before removing the metal top cover and replacing the internal battery among other processes.
Removing the Exhalation Corner Assembly is discussed in service manual revision D:
- Chapter 4: Assembly and Disassembly, Pg 51-52
PLEASE NOTE: This repair guide was developed by a student iFixit team based on Viasys/CareFusion's own service manual. Neither iFixit nor this repair guide is endorsed by or affiliated with Viasys or CareFusion.
-
-
Check to see if the exhalation filter assembly is installed, if it is, remove the exhalation filter assembly.
-
Rotate the metal locking lever on the lower right of the ventilator body forward to an open position.
-
Remove the exhalation filter assembly from the ventilator body by pulling straight down.
-
-
-
Using a long Phillips screwdriver, remove the Phillips screw located at the top of the exhalation filter assembly well, if applicable.
-
-
-
Using a long Phillips screwdriver, remove the Phillips screw located at the exhalation port marked EXH, if applicable.
-
-
-
Using a long Phillips screwdriver, remove the Phillips screw from the outside of the plastic cover.
-
-
-
Using a long Phillips screwdriver, remove the Phillips screw on the font left wall.
-
Using a long Phillips screwdriver, remove the Phillips screw on the right side of the wall.
-
Set the plastic cover aside.
-
-
-
Using a long Phillips screwdriver, remove the 3 Phillips screws on the metal re-enforcement cover, if applicable, and set aside.
-
Remove the Exhalation Corner Assembly.
-
To reassemble your device, follow the steps in the reverse order.
To reassemble your device, follow the steps in the reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935227:0crwdne2935227:0
crwdns2915084:0crwdne2915084:0
Cal Poly, Team S1-G1, Zimmerman Spring 2020 crwdns2935289:0Cal Poly, Team S1-G1, Zimmerman Spring 2020crwdne2935289:0
CPSU-ZIMMERMAN-S20S1G1
crwdns2931471:05crwdne2931471:0
crwdns2935297:06crwdne2935297:0
