crwdns2915892:0crwdne2915892:0
This guide is designed to provide you with simple steps to remove and replace the Verizon Ellipsis 10 Speaker. This replacement will resolve any sound quality issues.
crwdns2942213:0crwdne2942213:0
-
-
Open the SD/SIM card cover to start prying off the back cover.
-
-
-
Start using the iFixit Opening Tool in the SD/SIM area to release the clips holding the back panel on.
-
-
-
Follow along the edge of the device to undo all of the retaining clips.
-
-
-
Once all the clips are undone, the back panel should come off with little effort.
-
-
-
-
Remove the bottom piece of tape securing the battery making sure you are not peeling up anything else in the process.
-
-
-
Remove the top piece of tape using an iFixit opening tool.
-
-
-
Once you have a hold on the tape, carefully remove it making sure you aren’t damaging the battery in the process.
-
-
-
Unplug the battery power connector by sliding the white plastic plug down away from the board.
-
-
-
The battery should be free to come out of the device. Make sure not to bend or damage the battery.
-
-
-
Using a Phillips #00 screwdriver, remove the four M1.5 screws from the right speaker.
-
-
-
Remove the black and white wires connected to the motherboard by pulling up on their connections.
-
Remove the three strips of tape.
-
-
-
Remove the four M1.5 screws on the left speaker.
-
Remove the speakers from the device.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.