crwdns2915892:0crwdne2915892:0
Use this guide to reach the motherboard on your Micro Cruz T301. This guide will help you to reach the motherboard step by step.
crwdns2942213:0crwdne2942213:0
-
-
Insert the plastic opening tool in the SD port. The edge point should be pointed towards the rear panel.
-
-
-
Insert a small opening tool between the rear panel and the tablet.
-
-
-
The large opening tool is not needed any more.
-
-
-
Move the small tool opener around the rear panel to free the 12 edges.
-
-
-
Using PH0 Phillips Driver, remove the 4 Screws in the Metal part.
-
-
-
-
Using a plastic Spudger remove the battery connector.
-
-
-
Using PH0 Phillips Driver, remove the 12 Screws in the cover.
-
-
-
Place a metal Spudger between the tablet and the back cover.
-
-
-
Move the spudger around the tablet to release the clips attached to the tablet.
-
-
-
Use a plastic spudger to release the connection between the speakers and the motherboard as shown in the picture.
-
-
-
Use a nylon spudger to remove the top plug connector from the motherboard.
-
-
-
Use a metal spudger to remove both screen cable connectors
-
-
-
use openning tools to remove the motherboard.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.