crwdns2915892:0crwdne2915892:0
If there is no image coming from the baby monitor this could mean that circuit board need to be replaced. In order to replace the circuit board, you need a Phillips #00 Screwdriver.
crwdns2942213:0crwdne2942213:0
-
-
Remove the two 8 mm Phillips #00 screws from the back of the device.
-
Use the Jimmy tool to open the case.
-
Remove the face from the case.
-
-
-
-
Remove the three 8 mm Phillips #00 screws from the board.
-
Gently remove the board from the case.
-
crwdns2935219:0crwdne2935219:0
To reassemble your device, follow these instructions in reverse order.
crwdns2915888:0crwdne2915888:0
To reassemble your device, follow these instructions in reverse order.