crwdns2915892:0crwdne2915892:0
If the VTech VM3245 will not switch on, the battery may need to be replaced. The information below specifically states how to remove the battery and replace it with a new one. The only tools needed include a Phillips #00 screwdriver, Jimmy, and one opening pick. You will not have any difficult steps, but remove the front cover of the device attentively.
crwdns2942213:0crwdne2942213:0
-
-
Turn the monitor on its back, and remove the two 8 mm Phillips #0 case screws.
-
-
-
Use the iFixit Jimmy tool to begin removing the face of the monitor.
-
Once the screen has been separated, lift it from the case.
-
-
-
-
Remove the four 8 mm Phillips #00 screws from the bracket that secures the battery.
-
Remove the bracket.
-
-
-
Gently remove the battery from its location.
-
Carefully disconnect the bundled cable connector from the circuit board.
Wo finde ich denn genau solch eine Batterie ?
Besten Gruß
René
kroenung1990@googlemail.com
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2947410:01crwdne2947410:0
What is the battery that needs to be replaced called?