crwdns2915892:0crwdne2915892:0
During this guide, the back of the phone will be taken off by using the spudger. Then the circuit board will be detached by unscrewing two screws.
crwdns2942213:0crwdne2942213:0
-
-
Push down on the battery cover in the direction of the arrow located on the back of the phone.
-
-
-
Pull the battery cover off of the back of the phone.
-
-
-
-
Lift the battery out of the back of the phone.
-
-
-
Remove the two 9mm screws on the back side with a Phillips #0 screwdriver.
-
-
-
Use the plastic opening tool and spudger to pry the back side of the phone off.
-
-
-
Remove the two 9mm screws located inside the back cover at the top.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935229:03crwdne2935229:0
crwdns2915084:0crwdne2915084:0
IUPUI, Team 1-4, Baechle Spring 2016 crwdns2935289:0IUPUI, Team 1-4, Baechle Spring 2016crwdne2935289:0
IUPUI-BAECHLE-S16S1G4
crwdns2931471:04crwdne2931471:0
crwdns2935297:016crwdne2935297:0
crwdns2917034:0crwdne2917034:0
Thanks! Had to clean honey out if the speaker. Should Note the plastic quality is soft and can mark easily.
