crwdns2915892:0crwdne2915892:0
The back speaker is where the ring of the phone comes from.
crwdns2942213:0crwdne2942213:0
-
-
Starting from the top of the cover, slide down and away from the phone with your thumb
-
Lift battery cover off of batter and place it to the side
-
-
-
Once battery cover is removed, place your thumb and index fingers on the the wires near the receptacle
-
Gently pull straight up on the wires until a click is heard which signifies the battery is completely disconnected
-
Place battery pack to the side
-
-
-
Remove the two 11mm screws inside the battery storage compartment using Phillips #1 screwdriver (located near the very bottom of the phone)
-
-
-
-
Gently open phone casing along the seam at the bottom of the phone using index and middle fingers of both hands
-
-
-
Ensure that wired connection between circuit board and back shell is not strained
-
Fold the back shell underneath the front shell and circuit board
-
-
-
Lay the back shell with the inside facing up
-
To remove the speaker guard, first remove the 7mm screw from inside the back shell
-
-
-
To access the speaker, flip the back shell over and use a plastic opening tool to pop open the black cover
-
Gently push the speaker guard out of place with your thumb
-
Carefully slide the speaker out from its setting and place speaker guard aside
-
-
-
With speaker exposed, remove the speaker by cutting the red and black wires near their contact location
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2915084:0crwdne2915084:0
Clemson, Team 1-1, Benson Spring 2014 crwdns2935289:0Clemson, Team 1-1, Benson Spring 2014crwdne2935289:0
CLEM-BENSON-S14S1G1
crwdns2931471:03crwdne2931471:0
crwdns2935297:016crwdne2935297:0
