crwdns2942213:0crwdne2942213:0
-
-
Use an opening tool to pry off the lid of the memory card compartment.
-
-
-
Use a Phillips #00 Screwdriver to unscrew the two 1.2mm screws within the compartment. This allows the device to be opened.
-
-
-
Insert opening tools to partially pry open the cover.
-
-
-
-
With the cover being partially held open, slide a spudger around the seam to pry off the cover.
-
-
-
Remove the tape that is holding the battery in place.
-
-
-
Unscrew the five 1.2mm screws that connect the circuit board to the device.
-
-
-
There are three silver tabs around the internal components that connect it to the frame with screws. Unscrew these screws to remove the internal components.
-
-
-
Carefully lift the internal components from the screen and place them into a replacement screen.
-
To reassemble your device, follow instructions 1-7 in reverse order.
To reassemble your device, follow instructions 1-7 in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935229:02crwdne2935229:0
crwdns2915084:0crwdne2915084:0
UMass Dartmouth, Team S5-G5, Botvin Spring 2017 crwdns2935289:0UMass Dartmouth, Team S5-G5, Botvin Spring 2017crwdne2935289:0
UMASSD-BOTVIN-S17S5G5
crwdns2931471:03crwdne2931471:0
crwdns2935297:04crwdne2935297:0
crwdns2947410:01crwdne2947410:0
All the instruction are fine to follow except the last one, step 8. What tool to use to lift the internal components from the screen frame or where to start to lift without damage to the internal components?
