crwdns2942213:0crwdne2942213:0
-
-
To remove the ear cushions, press firmly down and rotate them clockwise, it should twist about 2mm and release, allowing you to pull it off.
-
-
-
Remove the screws (9.47 mm Phillips head) from the blue plating on the headset to reveal the inside.
-
-
-
-
If you are working on the LEFT side ear, you will first have to detach the battery by gently unplugging the white plug on the top of the board.
-
If you are working on the RIGHT side ear, you will first have to remove the charging contacts (2 7.92 mm Phillips screws).
-
-
-
Desolder the necessary wires. (Each side will be slightly different.)
-
Remove the 4 screws (7.71mm Phillips head) using the #0 screw bit, that are holding the board in place.
-
Finally, remove the audio board.
-
-
-
Remove the battery by carefully prying it from the headset.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935229:013crwdne2935229:0
crwdns2947412:055crwdne2947412:0
So there are two batteries in this headset that need to be replaced?
Also, what battery do I purchase and does anyone know a good source to purchase them?
Max battery size: 50x36x9mm
Origina battery: 40x30x8mm
The pcm board can be replacement by old battery module.
Only one battery inside. Not sure why this guide takes appart the whole headset.
All steps&pictures related to right side (step 1, 2 and 4) are misleading and unnecessary when doing just battery replacement.
I ordered replacement on aliexpress.
What part number please and thank you in advance