crwdns2915892:0crwdne2915892:0
This guide will exhibit how to replace the microphone board. Soldering is required to detach and replace the board, so refer to the soldering replacement guide for more information.
crwdns2942213:0crwdne2942213:0
-
-
Gently remove the foam pad from the microphone by pulling it apart.
-
-
-
-
Remove the PH0 7.1 mm screw from the back casing.
-
-
-
Remove the back casing from the microphone.
-
Desolder the two wires from the back of the microphone. For instructions on soldering, please see iFixit's soldering guide.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935229:07crwdne2935229:0
crwdns2915084:0crwdne2915084:0
Baylor, Team 10-14, Williams Fall 2015 crwdns2935289:0Baylor, Team 10-14, Williams Fall 2015crwdne2935289:0
BU-WILLIAMS-F15S10G14
crwdns2931471:03crwdne2931471:0
crwdns2935297:08crwdne2935297:0
crwdns2917034:0crwdne2917034:0
I have a turtle beach recon 200 and there is no category here for it. I have gotten water into my microphone and I do not know how to fix it. My mic is attached to the headset. I have tried blowing into it and wiping it. None of that works. Please help.
