crwdns2915892:0crwdne2915892:0
If the front-facing or rear-facing camera on your Trio Stealth-10 is no longer functioning, replacement isn't difficult and this guide will give you the step by step procedure to do so.
crwdns2942213:0crwdne2942213:0
-
-
To remove the back panel, you will need to use a plastic opening tool and slowly separate the back panel from the device.
-
-
-
Next use your PH 0 to remove the two 4mm screws to detach the camera support fixture.
-
-
-
-
Disconnect the camera from the mother board. Use a spudger and lift the grey latch until it is facing up then pull out the connection for the cameras.
-
-
-
Remove the first layer of tape above camera cable connection slowly.
-
-
-
Remove the second layer of tape above camera cable connection gently and remove the cameras from the device.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935229:02crwdne2935229:0