crwdns2915892:0crwdne2915892:0
If you are unable to use the touchpad of your laptop, use this guide to remove and replace the touchpad.
crwdns2942213:0crwdne2942213:0
-
-
Flip the phone over so that the back camera is facing you.
-
-
-
Use a your hands to remove the backing of the phone.
-
-
-
Use your phillips screwdriver to begin removing all the accesible screws.
-
-
-
Now begin to remove the coverings above and below the middle plate with your hand.
-
-
-
use your hand or a tool to remove the tabbing on the metal plate covering the battery.
-
-
-
Remove the metal plate covering the battery.
-
-
-
Use your wedging tool to begin removeing the adhesive under the battery.
-
-
-
Remove these two screws with your phillips screw driver.
-
-
-
-
Flip the phone back over with the screen facing you.
-
-
-
Begin to use the wedging tool to remove the space bar off of the keyboard.
-
-
-
remove the screws on each end of the space bars vacant lcoation.
-
-
-
Grab the wedging tool and begin wedging the old keyboard.
-
-
-
begind wedging the back of the keyboard until free.
-
-
-
Begin deperating the keyboard from the backing.
-
-
-
grab your replacement keyboard and connect it to the backing of the old keyboard.
-
-
-
place the keyboard back onto the front of the phone
-
-
-
once placed, hold the keyboard onto the phone while clicking the two metal plates back down to connect the keyboard.
-
-
-
Use a Phillips #1 screwdriver (PH1 bit) to remove the single 7 mm screw that secures the CD/DVD drive.
-
-
-
Slide the CD/DVD Drive out of the laptop.
-
-
-
Remove the thirteen 7 mm Phillips screws holding the back cover using the PH1 bit and Magnetic Driver.
-
-
-
Using the plastic opening tools, separate the back cover from the laptop.
-
-
-
Release the clamps holding the white ribbon between the touchpad component and the motherboard.
-
Slide the ribbon from the motherboard connection socket.
-
-
-
Remove the two 7 mm Phillips screws holding the touchpad component to the back panel using the PH1 bit and Magnetic Driver.
-
-
-
Release the two clamps connecting the blue ribbon to the external touchpad.
-
Lift the black clasp holding the blue ribbon in place.
-
-
-
Slide the blue ribbon from the external touchpad holding socket.
-
Lift the touchpad module from the laptop.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2915084:0crwdne2915084:0
South Arkansas Community College, Team S1-G1, Mitchell Spring 2018 crwdns2935289:0South Arkansas Community College, Team S1-G1, Mitchell Spring 2018crwdne2935289:0
SACC-MITCHELL-S18S1G1
crwdns2931471:04crwdne2931471:0
crwdns2935297:012crwdne2935297:0
