crwdns2942213:0crwdne2942213:0
-
-
Turn your laptop over so the underside is facing up.
-
-
-
Identify the two sliding locks on either side of the battery.
-
Simultaneously slide both locks outward to release the battery.
-
-
-
Pull the battery straight out of its slot to remove it.
-
-
-
Locate the optical drive retaining screw on the underside of the laptop.
-
-
-
Using a Phillips #00 screwdriver, remove the optical drive retaining screw.
-
-
-
-
Using your finger or a spudger, push the optical drive out of its compartment so you can grab it.
-
Pull the optical drive out of its slot in the side of the laptop.
-
-
-
Loosen the single screw on the service panel by twisting counterclockwise with a Phillips #00 screwdriver.
-
-
-
Using a spudger or plastic opening tool, pry off the service panel.
-
-
-
Using your fingers, pull the retaining clips away from the RAM sticks.
-
Pull the RAM sticks out of the slots.
-
-
-
Using a Phillips #00 screwdriver, remove all the remaining fourteen screws from the bottom case of the laptop.
-
-
-
Using a Phillips #00 screwdriver, remove the five screws under the service panel.
-
Remove the retaining clip.
-
-
-
Using a spudger, pry the keyboard from the top panel of the laptop.
-
-
-
Disconnect the two ribbon cables connecting the keyboard to the laptop.
-
Unplug the connector on the bottom of the laptop.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2915084:0crwdne2915084:0
UMass Dartmouth, Team S2-G1, Bailey Spring 2019 crwdns2935289:0UMass Dartmouth, Team S2-G1, Bailey Spring 2019crwdne2935289:0
UMASSD-BAILEY-S19S2G1
crwdns2931471:04crwdne2931471:0
crwdns2935297:021crwdne2935297:0
