crwdns2915892:0crwdne2915892:0
This guide shows how to remove and replace the two drivetrain V-belts for the Toro Cement Mixer 68009HD.
crwdns2942213:0crwdne2942213:0
-
-
Before you begin, press the engine-stop switch to turn off the engine.
-
-
-
Unlatch the three rubber straps securing the cowl.
-
-
-
Swing the cowl up until it rests securely on the frame.
-
-
-
-
Slide the fuel cutoff lever to the left to cut the fuel supply to the engine.
-
-
-
Grab the plastic housing at the end of the spark plug wire.
-
Pull firmly to disconnect the wire from the spark plug.
-
-
-
Remove the four fasteners securing the engine plate:
-
Two 14 mm bolts
-
Two 3/4 inch nuts
-
-
-
Slide the engine plate up and out of the device to remove it.
-
-
-
Use a 3/4 inch wrench to loosen the four bolts securing the engine to the frame.
-
-
-
Slide the belts off from the pulleys and remove them.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
