crwdns2915892:0crwdne2915892:0
Use this guide to remove the screen and motherboard in the TomTom XL. Removing the screen is necessary to access the XL's interior components.
crwdns2942213:0crwdne2942213:0
-
-
Slip a small plastic opening tool underneath the screen bezel, gently sliding it around the inside edge.
-
Starting at the corners, carefully pry up the screen bezel.
-
-
-
Remove the four Phillips #00 screws around the edge of the screen.
-
-
-
-
Slide a small plastic opening tool under the top portion of the metal frame and gently lift it up.
-
Slide the plastic opening tool around the inner edge of the metal frame until it feels loose.
-
Remove the frame from the housing.
-
-
-
Lifting from the upper edge of the screen, tilt the screen away from the device.
-
-
-
Remove the three Phillips #00 screws connecting the motherboard to the plastic housing:
-
Two Phillips #00 screws are located at the bottom of the first picture.
-
The third screw is hidden under the orange ribbon cable, near the screen.
-
-
-
Flip the screen and motherboard over.
-
Gripping the plastic casing, disconnect the battery cable connector from the motherboard.
-
Disconnect the speaker cable connector from the motherboard.
-
Remove the motherboard and screen from the housing.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935227:0crwdne2935227:0
crwdns2915084:0crwdne2915084:0
Cal Poly, Team 33-84, Johann Spring 2010 crwdns2935289:0Cal Poly, Team 33-84, Johann Spring 2010crwdne2935289:0
CPSU-JOHANN-S10S33G84
crwdns2931471:04crwdne2931471:0
crwdns2935297:05crwdne2935297:0
