crwdns2915892:0crwdne2915892:0
Before beginning this guide you should have completed guides on removing the back cover and separating the circuit board from the front cover.
crwdns2942213:0crwdne2942213:0
-
-
-
Remove the 4 .4mm screws on the back of the device.
crwdns2952109:0crwdne2952109:0
-
-
-
Using the palate knife tool, pry the back from the LCD screen. Apply a moderate pressure to separate them.
-
-
-
After prying both halves apart, they will be connected by two wires.
-
Carefully set the two halves next to each other making sure not to stress or damage the wires.
-
-
-
crwdns2935267:0crwdne2935267:0Tweezers$4.99
-
Using the tweezers separate the wires connecting the battery and speaker to the mother board.
-
-
-
-
-
Locate the 4 .4mm screws connecting the circuit board to the front panel.
-
Use the T6 Torx screwdriver and remove the four screws.
-
-
crwdns2935267:0crwdne2935267:0Tweezers$4.99
-
Locate the ribbon cable connecting the front panel to the circuit board.
-
Locate the white tab locking the ribbon in place.
-
Using precision tweezers push the left and right side of the tab forward.
-
Gently pull the ribbon to disconnect the circuit board from the front panel.
-
-
-
Use the palate knife to pry the screen away from the front panel.
-
Pry between the light gray board and the black boarder of the TOMTOM XL screen.
-
-
To reassemble your device, follow these instructions in reverse order.
