crwdns2915892:0crwdne2915892:0
This guide will show you how to replace or reconnect the charging port to the motherboard.
crwdns2942213:0crwdne2942213:0
-
-
Remove the 4 .4mm screws on the back of the device.
-
-
-
Using the palate knife tool, pry the back from the LCD screen. Apply a moderate pressure to separate them.
-
-
-
After prying both halves apart, they will be connected by two wires.
-
Carefully set the two halves next to each other making sure not to stress or damage the wires.
-
-
-
-
Using the tweezers separate the wires connecting the battery and speaker to the mother board.
-
-
-
If this is your first time solder then refer to IFixIt's safety guide.
-
Locate where the charger port goes on the circuit board.
-
Locate the four connecter on circuit board and charger port which need to be soldered.
-
-
-
Using your plastic opening tool press down firmly on the top of the charger port.
-
While the soldering iron is hot press it again the four corners of the charger port.
-
-
-
Let the circuit board and charger port cool down for a few minutes.
-
Lift circuit board up, after making sure its cool, to see if four corners are all connected.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2915084:0crwdne2915084:0
Colorado Springs, Team 9-6, Panko Spring 2015 crwdns2935289:0Colorado Springs, Team 9-6, Panko Spring 2015crwdne2935289:0
UCCS-PANKO-S15S9G6
crwdns2931471:03crwdne2931471:0
crwdns2935297:05crwdne2935297:0
