crwdns2915892:0crwdne2915892:0
This guide is to help instruct how to replace the motherboard of the TomTom Go 60 S. The motherboard in the main circuit for the device.
crwdns2942213:0crwdne2942213:0
-
-
Use the iFixit opening tool to pry open the TomTom Go 60 S. Start from a corner and drag the tool around the device.
-
-
-
Carefully pull the back cover apart from the front cover. Be careful not to pull too hard because there are two sets of wires connecting the device
-
-
-
-
Once the two covers are separated, use your fingers, to gently disconnect the wires that are connected to the motherboard from the back cover.
-
-
-
Next, you must remove the motherboard from the front screen.
-
Use a Phillips #000 screwdriver to unscrew the screws.
-
-
-
Separate the motherboard from the front cover, you must disconnect the wires connecting the two.
-
-
-
The motherboard is now disconnected from the front assembly
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2915084:0crwdne2915084:0
USF Tampa, Team 1-6, Nance Fall 2016 crwdns2935289:0USF Tampa, Team 1-6, Nance Fall 2016crwdne2935289:0
USFT-NANCE-F16S1G6
crwdns2931471:04crwdne2931471:0
crwdns2935297:05crwdne2935297:0
crwdns2947410:01crwdne2947410:0
What is the purpose of single yellow wire ?
is it ok if it is disconnected ? I fear to have unsoldered it or is it just an alone wire ?
Thanks
