crwdns2915892:0crwdne2915892:0
Use this guide to replace the pressure adjustment assembly in your Titan Impact 410 Airless Sprayer.
crwdns2942213:0crwdne2942213:0
-
-
Turn off and unplug the sprayer.
-
-
-
Use a Phillips driver to remove the four 12 mm-long screws securing the motor controller assembly.
-
-
-
Pull the motor controller assembly out and hold it to the side, exposing the cables.
-
-
-
Use a pair of needle nose pliers, or your fingers, to disconnect the two spade connectors from to the on/off switch.
-
Disconnect the one spade connector on the circuit breaker.
-
-
-
Disconnect the remaining spade connector from the on/off switch
-
Disconnect the jumper spade connector from the on/off switch and the circuit breaker.
-
-
-
-
Use your fingers to unscrew and remove the circuit breaker nut.
-
Remove the circuit breaker.
-
-
-
Use a flathead screwdriver to depress the locking tabs located on both the top and bottom of the on/off switch.
-
While depressing the tabs, push the on/off switch out through the cutout.
-
Remove the on/off switch.
-
-
-
Use a Phillips driver to remove the two 17 mm-long screws securing the contact switch.
-
-
-
Pull the contact switch away from the plunger and place it on the floor of the housing.
-
-
-
Use snap ring pliers to remove the retaining ring from the top of the plunger.
-
-
-
Loosen the pressure control knob.
-
Remove the pressure control knob.
-
-
-
Remove the pressure adjustment spring.
-
-
-
Remove the plunger.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935227:0crwdne2935227:0
