crwdns2915892:0crwdne2915892:0
How to disassemble the T3PM pedal set, clean it and keep it in the best possible condition.
crwdns2942213:0crwdne2942213:0
-
-
Unscrew all 6 screws from the pedal heads
-
Note the positioning of the pedal heads or take this opportunity to try out new position
-
-
-
Using Phillips screwdriver remove all screws at the bottom.
-
-
-
Remove the top cover and put it aside
-
-
-
-
Clean off any dust, residue, pet hair and other foreign debris that has accumulated inside the pedal set.
-
-
-
Make sure that the wires and the main cable are secure.
-
Replace sticky tape if necessary.
-
-
-
Clean off any dust, residue, pet hair etc from the pedals themselves, near the sensors and springs.
-
Make sure to clean off the extremities of the pedals.
-
-
-
Using an air-blower, compressed air-can or other tool, clean the sensors.
-
-
-
Inspect the conditions of the gas and clutch springs.
-
Re-lubricate if necessary.
-
To reassemble your device, follow the steps 1,2,3 in reverse order.
To reassemble your device, follow the steps 1,2,3 in reverse order.
