Teenage Engineering OP-1 Connector Board Disconnection

crwdns2931653:01crwdne2931653:0 Remove Back Panel




• Open the back panel by using a Jimmy on the side of the panel. Be careful not to damage the OP-1 coating.
• Lift the back panel and remove it. The Connector Board is revealed.
• Disconnect the flex connector by lifting it up with a spudger.
crwdns2913378:0crwdne2913378:0
crwdns2947430:01crwdne2947430:0
crwdns2934285:0crwdne2934285:0
crwdns2917038:0crwdne2917038:0
1024
crwdns2891542:0crwdne2891542:0 crwdns2934287:0crwdne2934287:0

crwdns2862417:0crwdne2862417:0

crwdns2935291:0crwdnd2935291:01crwdnd2935291:0crwdne2935291:0

teenage engineering

crwdns2935283:010/23/13crwdne2935283:0

1,095 crwdns2915208:0crwdne2915208:0

crwdns2935297:02crwdne2935297:0

crwdns2918514:0crwdne2918514:0: 11

• 
• 
• 

crwdns2935301:08crwdne2935301:0

crwdns2915084:0crwdne2915084:0

Teenage Engineering crwdns2935289:0Teenage Engineeringcrwdne2935289:0

Community

crwdns2931471:03crwdne2931471:0

crwdns2935297:07crwdne2935297:0

crwdns2942557:0crwdne2942557:0

crwdns2942955:0crwdne2942955:0

crwdns2852917:0crwdne2852917:0