crwdns2915892:0crwdne2915892:0
This guide will help you resolve any problem with your speaker on your Teddy Ruxpin model #17262DS. If the volume, sound quality, or general audio qualities of your bear are lacking this guide should help you fix those issues. A Phillips #1 screwdriver is required to complete this guide. Desoldering is also required so be sure to look at the desoldering guide for help.
crwdns2942213:0crwdne2942213:0
-
-
Remove the vest covering the back of the bear.
-
Orient the bear with his back facing upwards and unscrew the single Phillips #2 screw.
-
-
-
Pull the tab outward to remove the protective plate for the batteries.
-
-
-
Remove all four AA batteries by pushing the positive end down and pulling the battery out toward yourself.
-
-
-
Cut the orange shirt and zip tie.
-
Remove the zip tie.
-
-
-
-
Cut across the back seam of the head of the bear along the arrow.
-
-
-
Remove the interior of the doll.
-
Peel the outer layer around the head of the bear and forcefully pry off the face of the bear from the outside layer of the bear.
-
-
-
Pull off the rest of the outside layer of the bear.
-
-
-
Unscrew the eleven circled 12.5mm Phillips #1 screws.
-
Remove the top of the housing to access the electronics inside.
-
-
-
Unscrew the two 12.5mm Phillips #1 screws holding the speaker cap on and remove the speaker cap.
-
-
-
Desolder the wire from the speaker and replace.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935227:0crwdne2935227:0